Light- -RamaCTB16PCg3User Manual 16 Channel Lighting Controller Generation 3 User Manual October 14, 2011 V3.01 Copyright © Light O Rama, Inc. 200
CTB16PC 19 Testing the CTB16PC In the Max Units section of the Hardware Utility window, click the Change button. Move the slider in the Change Maximu
CTB16PC 21 The controller is not connected to a Light O Rama network or the network is not active. LED is on solid: Controller is connected to an act
CTB16PC 23 Firmware section. Find your controller and roll the mouse over the Firmware button – look at the bar in the lower left of the browser windo
CTB16PC 3 Introduction PlanetChristmas and Light-O-Rama (LOR) are proud to bring you the CTB16PCg3. This full function controller was designed with th
CTB16PC 5 What’s in the Box Included is a fully built and tested lighting controller and this user manual. The latest version of this manual is also a
CTB16PC 7 There are 1024 numbers in a curve file. The first number represents off and the last full brightness. A number in the curve file is a value
CTB16PC 9 Reset / Normal Operation Jumper There is a jumper on header JP3. JP3 is the smaller, 6-pin header to the lower left of the network connectio
CTB16PC 11 Auxiliary Display & Inputs Header This 20-pin header located on the upper left of the controller circuit board provides for an auxilia
CTB16PC 13 Click the Auto Configure button in the Setup Comm Port section. The Hardware Utility will search for the COM port that your RS485 adapter
CTB16PC 15 Click the “Advanced Configuration” button on the lower right. The Hardware Utility will read the current curve information from the contro
CTB16PC 17 Setting Multiple Channels in a Group You can change the curve association for multiple channels in channel group 1-8 or channel group 9-16
Comments to this Manuals